Airbag Control Modules - Pre-Programmed & Ready to Install

Verification requirements vary by manufacturer's control module:

• Used Toyota Airbag Controllers:
• • Camry SRS Module (2015-2023):
• - Module part number verification
• - ECU version compatibility
• - Crash data status check
• - Programming requirements
• • RAV4 Controller (2016-2023):
• - SRS unit inspection
• - Memory status verification
• - Sensor compatibility check
• - Network integration specs
• Used Honda Controllers:
• • Accord SRS Unit (2016-2023):
• - Module authentication
• - i-SRS compatibility
• - Programming status
• - Network verification
• • CR-V Modules (2017-2023):
• - SRS computer check
• - System integration status
• - Memory verification
• - Programming needs
• Used Ford Controllers:
• • F-150 RCM (2015-2023):
• - Module configuration
• - Security access status
• - Network integration
• - Programming verification
• Used Chevrolet Modules:
• • Malibu SDM (2016-2023):
• - Diagnostic history
• - Programming status
• - Security verification
• - System compatibility

Professional verification of module condition and programming status is essential.

Programming requirements vary significantly by manufacturer:

• Toyota Programming Needs:
• • Required Equipment:
• - Techstream software version
• - J2534 device compatibility
• - Security access codes
• - VIN programming
• Honda Programming Steps:
• • System Requirements:
• - HDS software access
• - Security initialization
• - VIN matching process
• - Network programming
• Ford Programming Specs:
• • RCM Programming:
• - IDS/FJDS requirements
• - As-built data entry
• - Security access
• - Network configuration
• GM Programming Protocol:
• • SDM Requirements:
• - MDI interface needs
• - Security access level
• - Configuration setup
• - System integration

Professional programming equipment and expertise required for all makes.

Each manufacturer has specific compatibility requirements:

• System Integration:
• • Network Requirements:
• - CAN bus protocols
• - Communication speed
• - Network topology
• - Gateway integration
• Vehicle Specifics:
• • Configuration Matching:
• - Airbag types supported
• - Sensor configurations
• - Impact detection setup
• - Deployment protocols
• Software Compatibility:
• • Version Requirements:
• - Operating system match
• - Calibration data
• - Security protocols
• - Update capabilities
• Hardware Requirements:
• • Physical Specs:
• - Mounting locations
• - Connector types
• - Pin configurations
• - Environmental ratings

Full compatibility verification required before purchase.

Diagnostic procedures vary by manufacturer system:

• Toyota Diagnostics:
• • Techstream Procedures:
• - DTC reading protocols
• - Zero point calibration
• - Sensor initialization
• - System testing
• Honda Verification:
• • HDS Testing:
• - SRS system scan
• - Component testing
• - Network diagnosis
• - Memory functions
• Ford Diagnostics:
• • IDS Procedures:
• - RCM verification
• - Network testing
• - Configuration check
• - System reset
• GM Testing:
• • MDI Protocols:
• - SDM diagnostics
• - System verification
• - Sensor testing
• - Code clearing

Use manufacturer-specific diagnostic tools for accurate results.

Safety protocols must be followed for all controller installations:

• Pre-Installation Safety:
• • Battery Procedures:
• - Disconnect protocols
• - Wait time requirements
• - Voltage verification
• - System discharge
• Installation Safety:
• • Mounting Requirements:
• - Location verification
• - Orientation check
• - Secure mounting
• - Ground connection
• System Integration:
• • Safety Checks:
• - Network verification
• - Sensor communication
• - System response
• - Warning light status
• Post-Installation:
• • Verification Steps:
• - System diagnostics
• - Function testing
• - Documentation
• - Safety certification

Follow all safety protocols and verification steps without exception.